FEATURES:

MAXIDECOR Sahara Fine is a high-quality, effective paint based on a water dispersion of acrylic binders, specially selected fillers, special additives and effective pigments. MAXIDECOR Sahara Fine has a slightly finer grain than MAXIDECOR Sahara decorative coating. It is intended for the protection and decoration of internal wall surfaces where it is necessary to create an exciting and dynamic effect. Can be tinted in the MAXIMIX system to MAXIDECOR Sahara and Sahara Fine.

OPERATIING TEMPARATURE: The optimal operating temperature is from +10 °C to +25 °C. It should not be used below +5 °C.

CONSUMPTION RATE: 7–9 m²/L, depending on the roughness and absorption of the substrate, the technique and the method of application

EXPIRY DATE AND STORAGE: 18 months from the production date marked on the packaging. To be stored in original, tightly closed and undamaged packaging, at a temperature of +5 °C to +25 °C, protected from direct sunlight.

USE:

The surface must be: dry, load-bearing, clean and free of loosely connected parts, dust, water-soluble salts, grease and other impurities. The old paint that is not well connected, mechanically remove. Uneven surfaces are leveled with acrylic smoothing mass GLETOLIN G. Then, on the surface apply MAXIDECOR Smooth or Quartz Primer, colored in the approximate shade of the finishing material, all according to the manufacturer's instructions. After the primer has dried, apply MAXIDECOR Saharu Fine, which is supplied ready to use, it only needs to be mixed by hand until homogeneous. MAXIMIX system tinted coatings and coatings from different batches and production dates must be homogenized! Application technique "Desert Storm": MAXIDECOR Saharu Fine in small quantities is gradually applied in one layer, with a brush movement in all directions, on a surface of 1-2 m². In optimal conditions, 5 to 10 minutes after application, dry brush again over the applied material, loosely "playing" with the sanding part to achieve the final look and remove any brush marks. Application technique "Desert Dunes": gradually apply the material in small quantities in one layer, with inclined, vertical or horizontal brush movements, on a surface of 1–2 m². In optimal conditions, 5 to 10 minutes after application, dry brush the applied material again, in opposite movements to the previous ones, to achieve the final look.